Advice needed.
-
Advice needed. I plan to use 2l water bottles to slowly water my tomato plants. There are various methods inc. tubing and aquarium stuff but I’m going for the simple one of planting the bottle upside down with tiny holes in the lid (base cut off). First I made 4 tiny holes as per instructions but I’ve had slower showers tbh. Way too fast. 2nd go had 1 tiny hole (1.5mm), tights fabric over lid. Slower but emptied overnight. Is that about right, any ideas? Thanks
-
Advice needed. I plan to use 2l water bottles to slowly water my tomato plants. There are various methods inc. tubing and aquarium stuff but I’m going for the simple one of planting the bottle upside down with tiny holes in the lid (base cut off). First I made 4 tiny holes as per instructions but I’ve had slower showers tbh. Way too fast. 2nd go had 1 tiny hole (1.5mm), tights fabric over lid. Slower but emptied overnight. Is that about right, any ideas? Thanks
@helenclayton I've had the same problem, would love to know what solutions (if any) exist.
-
Advice needed. I plan to use 2l water bottles to slowly water my tomato plants. There are various methods inc. tubing and aquarium stuff but I’m going for the simple one of planting the bottle upside down with tiny holes in the lid (base cut off). First I made 4 tiny holes as per instructions but I’ve had slower showers tbh. Way too fast. 2nd go had 1 tiny hole (1.5mm), tights fabric over lid. Slower but emptied overnight. Is that about right, any ideas? Thanks
@helenclayton I don't think that is a good idea at all. If Tomatoes get water continously they form only weak roots. I water my tomatoes when they're young only when they show that water is necessary by hanging tops, when they have set fruit every two days.
-
@helenclayton I've had the same problem, would love to know what solutions (if any) exist.
@RolloTreadway I thought a teeny hole would drain much more slowly. The more complicated bottle systems are literally like hospital drips but I don’t have the kit or appropriate supports for that. I looked into buying a small solar powered drip irrigation system but figured I could save money and reuse waste bottles if just needed for my tomato plants in the greenhouse.
-
Advice needed. I plan to use 2l water bottles to slowly water my tomato plants. There are various methods inc. tubing and aquarium stuff but I’m going for the simple one of planting the bottle upside down with tiny holes in the lid (base cut off). First I made 4 tiny holes as per instructions but I’ve had slower showers tbh. Way too fast. 2nd go had 1 tiny hole (1.5mm), tights fabric over lid. Slower but emptied overnight. Is that about right, any ideas? Thanks
@helenclayton I heard of plugging beer bottles with clay in Australia back in the day.
-
Advice needed. I plan to use 2l water bottles to slowly water my tomato plants. There are various methods inc. tubing and aquarium stuff but I’m going for the simple one of planting the bottle upside down with tiny holes in the lid (base cut off). First I made 4 tiny holes as per instructions but I’ve had slower showers tbh. Way too fast. 2nd go had 1 tiny hole (1.5mm), tights fabric over lid. Slower but emptied overnight. Is that about right, any ideas? Thanks
@helenclayton
What are those things that are used to control the drip of saline, in hospitals?Would a suspended 2l bottle with one of those things work, to control the drip rate?
-
@helenclayton I heard of plugging beer bottles with clay in Australia back in the day.
@Microplastics101 that sounds like a good Aussie solution. I do have a goodly number of wine bottles until the recycling is collected on Thursday so could hold onto those if can do something with them.
-
Advice needed. I plan to use 2l water bottles to slowly water my tomato plants. There are various methods inc. tubing and aquarium stuff but I’m going for the simple one of planting the bottle upside down with tiny holes in the lid (base cut off). First I made 4 tiny holes as per instructions but I’ve had slower showers tbh. Way too fast. 2nd go had 1 tiny hole (1.5mm), tights fabric over lid. Slower but emptied overnight. Is that about right, any ideas? Thanks
@helenclayton I don't know if buying something is an option in your case but I remember that porous bottle caps worked well, something like that: https://www.leroymerlin.fr/produits/emetteurs-eau-poreux-argile-marron-geolia-200-ml-lot-de-4-goutteurs-auto-irr-88923974.html
There exists several grades of porosity that make a bottle last several days to a week. We used to save our plants like that when we were going for vacations. -
@helenclayton
What are those things that are used to control the drip of saline, in hospitals?Would a suspended 2l bottle with one of those things work, to control the drip rate?
@Maker_of_Things that was one of the other methods I looked at but it requires kit I do not have and I don’t have a means of hanging the bottles. Not 10 of them anyway. I’d like to use what I have to hand…and preferably today.
-
Advice needed. I plan to use 2l water bottles to slowly water my tomato plants. There are various methods inc. tubing and aquarium stuff but I’m going for the simple one of planting the bottle upside down with tiny holes in the lid (base cut off). First I made 4 tiny holes as per instructions but I’ve had slower showers tbh. Way too fast. 2nd go had 1 tiny hole (1.5mm), tights fabric over lid. Slower but emptied overnight. Is that about right, any ideas? Thanks
@helenclayton I would, instead, drill a couple of those small holes in the base, maybe one per each of the little bumps, then bury it until just the top is open, fill it and then put the cap on. The goal is to only allow a small amount of air in to replace the water, such that it wicks out the bottom. Look up ollas for the general idea.
-
@helenclayton I don't know if buying something is an option in your case but I remember that porous bottle caps worked well, something like that: https://www.leroymerlin.fr/produits/emetteurs-eau-poreux-argile-marron-geolia-200-ml-lot-de-4-goutteurs-auto-irr-88923974.html
There exists several grades of porosity that make a bottle last several days to a week. We used to save our plants like that when we were going for vacations.@Armavica thank you. I’ll have a look. I was hoping to avoid buying something because ideally I’d plant on my toms today. If I can’t make the holes work it’s probably a cheaper option than some others.
-
Advice needed. I plan to use 2l water bottles to slowly water my tomato plants. There are various methods inc. tubing and aquarium stuff but I’m going for the simple one of planting the bottle upside down with tiny holes in the lid (base cut off). First I made 4 tiny holes as per instructions but I’ve had slower showers tbh. Way too fast. 2nd go had 1 tiny hole (1.5mm), tights fabric over lid. Slower but emptied overnight. Is that about right, any ideas? Thanks
@helenclayton I’m not sure you’re supposed to cut the base off? At least in southern Europe people simply put glass bottles bottom-up in their planters. When the soil is saturated already it preserves moisture.
-
@helenclayton I would, instead, drill a couple of those small holes in the base, maybe one per each of the little bumps, then bury it until just the top is open, fill it and then put the cap on. The goal is to only allow a small amount of air in to replace the water, such that it wicks out the bottom. Look up ollas for the general idea.
@blackcoat oh ok, thanks. I saw ollas but didn’t realise I could make something like that with plastic bottles. I’ll try that. Does it have to be completely buried (might struggle with that) Hopefully I’ve got enough bottles!
-
@Maker_of_Things that was one of the other methods I looked at but it requires kit I do not have and I don’t have a means of hanging the bottles. Not 10 of them anyway. I’d like to use what I have to hand…and preferably today.
@helenclayton
Ahhh...
Would a wick from the bottle work?
Instead of tiny holes in the cap, one hole but with cloth bunged into it. It would wick the water out very gradually, and collapse the bottle as the water volume reduces. -
@helenclayton I’m not sure you’re supposed to cut the base off? At least in southern Europe people simply put glass bottles bottom-up in their planters. When the soil is saturated already it preserves moisture.
@Koefoed with this method that was the instruction, so you can leave the bottle in situ and fill as needed. I have seen the use of bottle spikes that wine bottles etc are placed (full) neck down into. Before I buy anything though I’d like to see if I can make the waste bottles work.
-
@helenclayton
Ahhh...
Would a wick from the bottle work?
Instead of tiny holes in the cap, one hole but with cloth bunged into it. It would wick the water out very gradually, and collapse the bottle as the water volume reduces.@Maker_of_Things possible but it would still need to be hung up somewhere.
-
Advice needed. I plan to use 2l water bottles to slowly water my tomato plants. There are various methods inc. tubing and aquarium stuff but I’m going for the simple one of planting the bottle upside down with tiny holes in the lid (base cut off). First I made 4 tiny holes as per instructions but I’ve had slower showers tbh. Way too fast. 2nd go had 1 tiny hole (1.5mm), tights fabric over lid. Slower but emptied overnight. Is that about right, any ideas? Thanks
@helenclayton IV Flow Regulator? I found a random one on AliExpress for a couple of quid that goes down to 5ml/hour (and up to 250ml/hour), which is over 1 week for a litre. I'm quite tempted to get a few and try it.
-
@Koefoed with this method that was the instruction, so you can leave the bottle in situ and fill as needed. I have seen the use of bottle spikes that wine bottles etc are placed (full) neck down into. Before I buy anything though I’d like to see if I can make the waste bottles work.
@helenclayton the spike thing is like this, I think. Only without spikes. But with the method you describe, I don’t know. Sorry if I derail your question. https://youtu.be/Z2Ro6OUO8UM?si=dETlbgFStH9PDloe
-
@helenclayton IV Flow Regulator? I found a random one on AliExpress for a couple of quid that goes down to 5ml/hour (and up to 250ml/hour), which is over 1 week for a litre. I'm quite tempted to get a few and try it.
@drj that was one of the other methods but using a regulator thing for aquariums (same principle). I could buy them but the rest of the set up will be difficult (hanging bottles etc).
-
Advice needed. I plan to use 2l water bottles to slowly water my tomato plants. There are various methods inc. tubing and aquarium stuff but I’m going for the simple one of planting the bottle upside down with tiny holes in the lid (base cut off). First I made 4 tiny holes as per instructions but I’ve had slower showers tbh. Way too fast. 2nd go had 1 tiny hole (1.5mm), tights fabric over lid. Slower but emptied overnight. Is that about right, any ideas? Thanks
@helenclayton you may be able to slow the rate further with coarse sand to partially block the holes. You could also try string wicks for even slower watering
