I purchased some #Bambu filament refills and am struggling.
Ikke-kategoriseret
1
Indlæg
1
Posters
0
Visninger
-
I purchased some #Bambu filament refills and am struggling. I got them on the spool without any issues, and then used the one visible filament end (which is bent 90 degrees at the end, to make it easier to find I assume?). But the filament immediately pulls below the spooled-up part, which massively increases friction and leads to my printer being unable to pull it in, the spool wobbling while being unrolled, etc.
Where is my mistake? Is there another end visible that I should find and use instead? I am so confused right now - already messed up one spool beyond repair because I also didn’t lock the spools properly, now on my second refill pack but still can’t get it to work because of this… any help would be appreciated.
-
J jwcph@helvede.net shared this topic